Filter
Top Products
5-33
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
OL-3410-01
Chapter 5 Parameters and Defaults
Operating Parameters
Table 5-5 SigTimer Parameter Bit Definitions
Bit Number Definition
0-7 Call waiting period—The period between each burst of call-waiting tone.
Range: 0 to 255 in 0.1 seconds
Default: 100 (0x64=100 seconds)
8-13 Reorder delay—The delay in playing the reorder (fast busy) tone after the far-end caller hangs up.
Range: 0 to 62 in seconds
Default—5 (seconds)
63—Never play the reorder tone.
14-19 Ring timeout—When a call is not answered, this is the amount of time after which Cisco ATA rejects the
incoming call.
Range—0 to 63 in 10 seconds
Default—6 (60 seconds)
0—Never times out
20-25 No-answer timeout—The time to declare no answer and initiate call forwarding on no answer (used in SIP
only
Range—0 to 63 in seconds
Default—20 (0x14=20 seconds)
26-27 Minimum hook flash time—The minimum on-hook time required for hook flash event.
Range: 0 to 3
Default: 0 (60 ms)
Other possible values: 1=100 ms, 2=200 ms, 3=300 ms.
28-31 Maximum hook flash time—The maximum on-hook time allowed for hook flash event.
Range: 0 to 15
Default: 0 (1000 ms)
Other possible values: 1=100 ms, 2=200 ms, 3=300 ms, 4=400 ms, 5=500 ms, 6=600 ms, 7=700 ms, 8=800
ms, 9=900 ms, 10=1000 ms, 11=1100 ms, 12=1200 ms, 13=1300 ms, 14=1400 ms, 15=1500 ms.