Filter
Top Products
5-28
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
OL-3410-01
Chapter 5 Parameters and Defaults
Operating Parameters
ConnectMode
Description
This parameter is a 32-bit bitmap used to control the connection mode of the selected call signaling
protocol. Table 5-4 on page 5-28 provides bit definitions for this parameter.
Value Type
Bitmap
Default
0x00060400
Voice Configuration Menu Access Code
311
Table 5-4 ConnectMode Parameter Bit Definitions
Bit Number Definition
0—H.323 only 0—Enable normal start.
1—Enable fast start.
1—H.323 only 0/1—Disable/enable h245 tunneling.
2 0—Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
1—Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
3—H.323 only 0/1—Disable/enable the requirement for the alternate gatekeeper to register.
4—H.323 only 0—Denotes a non-Cisco CallManager environment.
1—Enable the Cisco ATA to operate in a Cisco CallManager environment.
5—H.323 only 0/1—Enable/disable two-way cut-through of voice path before receiving CONNECT message.
6—H.323 only 0/1—Disable/enable using the Progress Indicator to determine if ringback is supplied by the far end with
RTP.
7 0/1—Disable/enable fax pass-through redundancy.
8-12 Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number
of 96. The valid range is 0-23; the default is 4.
For example, if the offset is 4, the NSE payload type is 100.
13 0—Use G.711µ-law for fax pass-through codec.
1—Use G.711A-law for fax pass-through codec.
14-15 0—Use fax pass-through.
1—Use codec negotiation in sending fax.
2—Reserved.
3—Reserved.
16—SIP only 0/1—Disable/enable SIP to remove the registration before adding a new one.