Filter
Top Products
6
Setting up follow these steps to get your Synergy 900
ready for use.
BATTERY
Push
Slide
WARNING
It is recommended that the line cord is not
connected until the handset is fully charged.
This will prevent the risk of the phone being
answered prior to the battery being fully
charged and therefore not working to its
optimum capacity.
2. Connect the power cable
Plug the power cable into the power socket on
the underside of your Synergy 900. When the
power is switched on, the base station
POWER
light comes on.
3. Install the rechargeable battery in
the handset
Hold the handset with the keypad facing down,
remove the clear plastic directory label cover
and press and slide open the battery
compartment.
Insert the battery pack inside the battery
compartment and slide the battery compartment
cover shut. Replace the directory label cover.
1. To plan the location of the base
station
Your Synergy 900 works by sending and
receiving radio signals between the base station
and the handset.
The strength of the signal depends on where
you site the base station. The higher the base
station is located, the better. An upstairs room is
ideal. The following points should be considered:
• It should be within 2 metres of a power socket
and phone socket otherwise extension cables
will be required
• Try to avoid locations near metallic obstructions
or electrical appliances, such as TV sets,
fridges, computers, fluorescent lights, radiators,
metal pipes and metal window frames.