Filter
Top Products
24
Using additional handsets
Registering an additional Synergy
handset with the base station or
re-registering a handset
Up to six handsets can be registered and
operated from the Synergy 900 base station.
The system allows intercom calls between two
handsets while a third is making an external call.
Each additional handset you purchase must be
registered with the base station.
To register a handset
At the base station:
• Press and hold down the blue
PAGE button
until you hear a beep (after about 10 seconds).
At the handset:
• Press the ➔ button several times until the
display shows SET UP.
• Press the ✔ button. Display shows HANDSET.
• Press the ✔ button. Display shows LEVEL.
• Press the ➔ button several times until the
display shows REG.
• Press the ✔ button. Display shows ADD.
• Press the ✔ button. Display shows PLS WAIT
then, after a short delay, the Park No. of the
base station.
• Press the ✔ button. Display shows PIN ----.
• Enter the four-digit base station code.
(Default 0000. Enter this if the base station
code has not been changed.) The ----marks
disappear one by one.
• Press the ✔ button. You hear a confirmation
beep. Display shows LABEL = (which refers to
the handset number).
• Press the ✔ button to automatically allocate
the next handset number.
• If you are re-registering your only or first
handset, enter
1, followed by the ✔ button.
You hear a confirmation beep.
Before registering a new handset
Remember to charge the batteries for at least
16 hours. When switched on, the handset will
display
RREEGG
. This tells you that the handset is
nnoott rreeggiisstteerreedd
with the base station.
You now have up to 1 minute to register the
handset, during which the IN-USE light f lashes
on the base station.
Park No. is a unique number given to each
individual base station