19
Setting your own base station PIN code
You can set your own four-digit code number for
your Synergy 900 base station. This prevents
unauthorised users from registering or de-registering
handsets on your Synergy 900 base station.
• Press the ➔ button until the display shows SET UP.
• Press the ✔ button. Display shows HANDSET.
• Press the ➔ button. Display shows BASE.
• Press the ✔ button. Display shows SECURITY PIN.
• Press the ✔ button. Display shows
OLD PIN ----. (default 0000).
• Enter the current PIN code (default 0000).
The ---- marks disappear one by one. The
entered numbers are not displayed.
• Press the ✔ button. Display shows
NEW PIN ----.
• Enter the new PIN number. The ----marks
disappear.
• Press the ✔ button. Display shows
NEW PIN ----again. Re-enter the new PIN
number, so that the base station can check
that there was no mistake on entering the PIN.
• Press the ✔ button.
• The display shows OK. You hear a confirmation
beep. The display then changes to HSET 1.
Keep a record of your PIN number in the boxes
on the fold-out page at the front of this guide.