Filter
Top Products
15
To switch the keypad beeps on and off
Whenever you press a button on the handset,
you will hear a beep. You can turn this sound on
and off. The original setting is ON.
• Press the ➔ button several times until the
display shows SET UP.
• Press the ✔ button. Display shows HANDSET.
• Press the ✔ button. Display shows LEVEL.
• Press the ➔ button. Display shows KEYTONES.
• Press the ✔ button. Display shows the
current setting ON or OFF.
• Press the ➔ to change the setting. Display
shows OFF or ON.
• Press the ✔ button. A beep confirms that the
change has been made.
To reset your Synergy 900 base station to its
original settings
• Switch off the mains power.
• Press and hold down the
PAGE button.
Continue to hold down the
PAGE button while
switching the mains power back on and for a
further five seconds until the base station
gives a confirmation beep. After another five
seconds a second confirmation beep will
indicate that the base station reset is complete.
This will reset:
Base station PIN code to 0000.
Dial delay.
Recall mode.
Ringer volume.
Ringer melody.
It will remove:
All handsets registered to the base station.
All shared numbers stored in the memory.
Press the ✗ button to reverse one step of the
instructions. Or press and hold to revert
quickly to standby.