Filter
Top Products
Synergy 2150 - Edition 7 – 30th May ’00
Connecting to a switchboard
When connecting your Synergy 2150
to a switchboard/PBX, you may need
to change the dialling mode from
TONE to PULSE.
The dialling mode is set to
TONE when the product is
supplied.
To change to PULSE.
Until display flashes
Base
setting
.
PIN Enter the 4-digit base station
PIN. Original setting 0000.
Until the display flashes
Dial mode.
Until the display flashes
Pulse.
To confirm setting.
To change the dialling mode
Options
Options
Options
45
Del
Options
Del
Options
Del
When connected to some
switchboards/PBX’s you
may encounter higher than
normal speech levels. If this
is the case you can alter the
network setting from PSTN
to PBX which would reduce
the levels to normal.
Until the display flashes
Base setting.
PIN Enter the 4-digit base station
PIN. Original setting 0000.
Until the display flashes
Network.
Until PBX is flashing.
To confirm the setting.
To change the network
connection
Options
Options
Options
Del
Options
Del
Options
Del
SWITCHBOARD
Synergy 2150 user guide 31/5/00 10:41 Page 44