BT 2150 Cordless Telephone User Manual


 
Synergy 2150 - Edition 7 – 30th May ’00
9
Safety instructions
Use only the approved
battery pack supplied. Spare
batteries – Item Code: 871996
are available from BT Shops and the
Synergy Helpline 0845 602 1041.
Do not try to use any other power
supply except the one provided,
otherwise you may permanently
damage your Synergy 2150. It may also
invalidate approval of this apparatus.
To get a replacement Synergy 2150
base station power supply unit – Item
Code 872073 – contact the Synergy
Helpline 0845 602 1041.
There is a slight chance your
phone could be damaged by
an electrical storm. We
recommend that you unplug your
Synergy 2150 from the mains power
and telephone socket during storms.
The Synergy 2150 will
produce a certain amount of
heat during operation.
Equally, the handset as well as any
additional chargers you purchase can
also become warm during charging.
We advise against placing these
products on antique, veneered or
wooden surfaces as damage may occur.
Do not use the Synergy 2150
in damp, humid conditions
such as bathrooms. Do not
expose the equipment or batteries to
fire and water.
Do not dispose of used
batteries with general
household rubbish and do not
burn them.
Do not use the handsets in
places where there are
explosive hazards.
If you wear a hearing aid,
please note that the Synergy
2150 works by sending radio
signals between the base station and
handset. These signals can interfere
with hearing aids, causing a humming
noise.
We advise that this product should not
be used near emergency intensive care
medical equipment and should not be
used by individuals with pacemakers.
Synergy 2150 can interfere with other
electrical equipment, e.g. answering
machines, TV and radio sets, clock
radio/alarms and computers if placed
too close. It is recommended that you
place your Synergy 2150 at least one
metre away from such appliances to
minimise any risk of interference.
Make sure you connect the power and
telephone lines to the correct sockets
in the base station.
Clean the handset and base station with
a damp (not wet) cloth or antistatic
wipe. Never use a dry cloth as this
may cause a static shock. Never spray
cleaning fluid directly onto the telephone.
SAFETY INSTRUCTIONS
Synergy 2150 user guide 31/5/00 10:39 Page 8