Filter
Top Products
29
At the base station:
• Press and hold down the
GREY
paging button until you hear the beeps
(after about 10 seconds).
At the handset:
• Press and hold down the 2 button
(or 3 or 4), to allocate a number to
the new base station.
• At the same time, hold down the PWR
button until the display shows.
• Enter the system code.
(Standard setting 0000.)
• Press the
#
button. The beeps stop
after a few seconds, and the display
shows all available handset numbers.
• Enter the single digit handset number
– from 2 to 6 – for the additional
handset. It is now registered.
If six handsets are already registered with
the base, three dashes will appear in the
display after you enter the system code.
Please note that you cannot move between
base stations whilst a call is in progress. If
you attempt to do so, your will lose your
connection.
2
23456
PWR
#
2-6
To set/clear the base station number
display from a handset
The standard setting is for the handset
not to show the number of the base
station to which it is registered. If your
handset is connected to more than one
base we recommend that you activate
this display.
• Press the STO button.
• Press the 3 button, then 6.
The current setting is displayed.
• Press the 1 button to display the base
station number.
Or
• Press the 0 button if you do not want
to display the base number.
• Press STO to confirm.
To set your handset for automatic
base selection
If you are moving around, and likely to
lose contact with your base station, your
handset can be made to automatically
switch to the best available base station.
This means that if you are in an area
where the signals of two base stations
overlap, your handset will select the
strongest signal.
STO
1
0
3
DEF
6
MNO
You now have up to 1 minute to register
the handset, during which the beeps will
continue.
3
DEF
4
GHI
2
ABC
or or