Filter
Top Products
33
Batteries
Before you first use the handset, you should have left it on
the charger pod for up to 15 hours to charge the batteries
fully. Repeat this.
You may need to replace the batteries. Contact the
Binatone Help Line for advice.
Clean the battery charging contacts with a dry cloth.
Check the connections between the base unit and the
mains power socket.
You need to replace the batteries. Please note these
safety warnings:
Use only NiMH (Nickel Metal Hydride) rechargeable
batteries, as supplied with the handset.
Dispose of used batteries safely - never burn them, or
put them where they could get punctured.
Using your Big Button Combo on a PBX
When you first make a call, try pressing the button for
a pause between the outside line access digit (e.g. 9) and
the telephone number. You should later be able to redial the
number.
When storing numbers in memory, you can include the
outside line access digit (e.g. 9) with each number.
If your PBX requires you to wait for a second Dial tone
before dialling the telephone number, press the button
for a pause between the access digit and the number.
You may need to change the recall setting. On the cordless
handset, press and hold the button, select ‘S’ for 100
ms or ‘L’ for 250 ms.
If in doubt, call the Help Line for advice. It will help if
you have your PBX documentation to hand when you
make the call.
“The handset‘s
batteries are
running low
within an
hour or two.”
“The CHARGE
light on the
charger pod does
not come on.“
“I try to recharge
the batteries, but
I still get a
warning that they
are low.”
“Last Number
Redial and/or
memory dialling
don’t work.”
“My phone
won’t work
properly on a PBX”
Troubleshooting
Binatone Help Line: 0845 345 9677