Filter
Top Products
37
Symptom
The remote control does not work
BeoTalk 1200 is ”dead”
A number called from a parallel
telephone is not shown in the display
The clock does not show the correct time
While playing messages using remote
control, BeoTalk 1200 executes
commands you have not asked for
BeoTalk 1200 answers a Call-back
The telephone answering machine does
not answer a phone call when ringing
It is not possible to record a new
announcement
Voice Announcement, Group
Announcement and Rejection of
incoming calls do not function
Possible cause
• The PIN-code has not been entered
• The telephone from which you call
does not transmit tones
• BeoTalk 1200 is being operated locally
• The connection is poor
BeoTalk 1200 has been incorrectly
connected
The telephone from which you call does
not transmit DTMF tones
Power failure
A message contains DTMF tones
BeoTalk 1200 registers the call as an
ordinary call
• The telephone answering function has
been deactivated
• The ringing time is too long
Memory is full
The complete telephone number,
including area code, has not been stored
in the list
Possible correction
• Enter the access code
• Call from another telephone
• Try call again later
• Call from another telephone
Check the connection
Set the clock
• Press and continue the operation, or
• Replace the handset and call again
Deactive the answering machine function
until the Call-back has been concluded
• Activate the answering machine
function
• Set the ringing time
Press C to delete the old announcement
(while playing the announcement)
Store the complete number (at least three
and maximum 13 digits). Please note that
in some regions you need not to enter the
area code. This you will know by looking
at the display seeing how the incoming
phone numbers are shown. You must store
your numbers in the same way