Filter
Top Products
36
Symptom
The answering machine function cannot
be activated
A new number is shown in the display,
but you will hear only one ringing tone
Some subscribers cannot call you
The display is illuminated though all
messages have been played
is shown in the display and the
display is illuminated
BeoTalk 1200 answers the call sooner
than the pre-programmed ringing time
The phone rings more than one time
when using Rejection of incoming calls
The index numbers are not shown in the
display as described in this guide
BeoTalk 1200 continues to play the
announcement after you have answered
the call
Possible cause
No announcement has been recorded for
the type of announcement chosen
• Rejection of incoming calls has been
activated
• The ringing time has been set to 4
seconds
The numbers exist in the Rejection list,
and the function has been activated
There are further new messages (Caller
ID calls or messages)
• BeoTalk 1200 has not been connected
to the telephone plug
• A telephone is off-hook
New messages received and at the same
time the Toll saver has been activated
• Technical limitations
• Rejection has not been activated
The phone numbers have more than 10
digits
BeoTalk 1200 has not registered that you
have answered the call
Possible correction
Record an announcement and activate
the type of announcement
Scroll through the News list
• Connect BeoTalk 1200 to the
telephone plug
• Replace the handset
• Replace the handset briefly
or
• Press the NEWS or STORE key on
BeoTalk 1200
Worth knowing – about troubleshooting