Filter
Top Products
H323 IP Telephone Installation Page 55
15-601046 Issue 16a (15 March 2010)IP Office Release 6
Static Administration Options:
4.1 QOS Option Settings
Administering QoS options is not mandatory, but it is highly recommended. Use the following procedure to set Quality of
Service (QoS) options.
1.
While the phone is on-hook and idle, press the following sequence: MUTE 7 6 7 # (MUTE Q O S #).
2.
The current 802.1Q settings are shown in sequence:
· L2 audio=
This is the phone's current 802.1 audio parameter. To accept the current value, press # or enter a value
(between 0 and 7) and then press #.
· L2 signaling=
This is the phones 802.1 signaling parameter. To accept the current value, press # or enter a value (between 0
and 7) and then press #.
· L3 audio=
This is the phone's Differential Services audio parameter. To accept the current value, press # or enter a value
(between 0 and 63) and then press #.
· L3 signaling=
This is the phone's Differential Services signaling parameter. To accept the current value, press # or enter a
value (between 0 and 63) and then press #.
3.
If no new values were entered during this procedure, No new values is displayed. To end the procedure, press #.
4.
If new values were entered during this procedure, Save new values? is displayed. To end the procedure or save
the new values, press #. New values being saved is displayed and the phone returns to normal operation.
4.2 Secondary Ethernet (Hub)/IR Interface Enable/Disable
Use the following procedure to enable or disable the hub interface found on some H323 IP phones (usually marked with a
symbol). The default for the hub interface is enabled.
The same procedure can also be used to enable or disable the IR port found on some H323 IP phones, see Infrared
Dialling .
1.
While the phone is on-hook and idle, press the following sequence: MUTE 4 6 8 # (MUTE I N T #). The phones
port settings are shown in sequence. The option vary between different models of phone.
· PHY2=
This is the PC connection LAN socket marked as on the phone. Press 1 or 0 to enable or disable the hub
interface respectively. To continue, press #.
· IR=
This is the infrared (IR) port located on the front of some H323 IP phones. Press 1 or 0 to enable or disable the
hub interface respectively. To continue, press #.
2.
If you changed the setting, Save new values? is displayed. To end the procedure or save the new values, press #.
If you press #, New values being saved is displayed and then returns to normal operation.
66