Filter
Top Products
Avaya 3626 Wireless Telephone, Desktop Charger and Gang Charger
with CCMS
Page 20 555-301-710
Issue 1
4. The Gang Charger
The Avaya Gang Charger is designed to charge
four Nickel Metal Hydride (NiMH) Battery Packs
simultaneously. Full charging is accomplished in
approximately one and a half hours. Chargers
operate in a 50° to 85° F (10° to 30° C)
environment. Do not expose them to freezing
temperatures or direct sunlight.
The Gang Charger is shipped with the appropriate power
supply for the site’s location. Place the Gang Charger on a
flat, horizontal surface. Plug the power supply into the
Gang Charger and into an appropriate wall outlet.
Caution
Do not place anything in the Desktop Charger other than
the Wireless Telephone. You might damage the contacts.
Bent contacts can keep the Battery Pack from charging.
Using the Gang Charger
Remove the Battery Pack from the Avaya 3626 Wireless
Telephone by depressing both battery release buttons. The
Battery Pack will release.
Insert the Battery Pack into one of the four charging bays
so that the Battery Pack contacts meet the charging bay
contacts. The LED above the charging bay will turn on to
indicate that charging is in progress. Complete charging
occurs in one and a half to two hours. The Battery Pack is
partially charged in five minutes.
When charging is complete, the LED will turn off. Lift the
Battery Pack out of the charging bay.
Blinking LED
If the LED starts blinking as soon as the Battery Pack is
inserted, the Battery Pack may be improperly seated. Lift it
out and reinsert. If the LED continues to blink or starts
blinking at any time during the charging process, it
indicates that there is a problem with the Battery Pack that
makes it unusable. Do not continue to charge the Battery
Pack. Dispose of it properly and do not attempt to use it in
the Wireless Telephone. Do not attempt to open or repair a
defective Battery Pack. Contact your service representative
for assistance.
(shown with two empty charging bays)