Filter
Top Products
Avaya 3626 Wireless Telephone, Desktop Charger, and Gang Charger
with CCMS
555-301-710 Page 15
Issue 2
Push to Talk (PTT) – continued
Incoming PBX call
during a PTT call
A telephone call may be answered while in a PTT call
session. To announce an incoming call, the Wireless
Telephone will ring with a low-volume ring and display the
system message.
To answer the call, press Power On / Start Call. The PTT
call session will be pre-empted and no PTT audio will be
heard.
After the PBX call is over, press Power Off / End Call as
usual to go back on hook, at which time PTT goes out of
pre-empted mode and becomes active again. If an already
active PTT call has not ended, the PTT audio starts playing
again.
If the user does not answer the telephone call by pressing
Power On / Start Call, the PTT display will be shown after
the ring has stopped.
Making a PBX call
during a PTT call
To start a telephone call during a PTT call session, press the
Power On / Start Call key. This causes the two-way radio
to be pre-empted as described above.