Filter
Top Products
25
Replacing a headset
You may need to deregister your headsets if:
You have two registered headsets and need to replace one of them.
-OR-
You wish to change the designated headset number and/or the
colors of the ON/OFF lights of your registered headsets.
You must first deregister both headsets, and then register each
headset you wish to use again, one at a time.
Please read carefully through all the instructions before
beginning the deregistration process.
To deregister all headsets from your TL7610/TL7611/TL7612
headset base
This procedure deregisters all the items registered to the headset base.
Press and hold PAIR on the TL7610/TL7611/TL7612 headset
base until the MUTE light on the headset base turns on and starts
to flash (at least 10 seconds), then release the PAIR button.
Immediately press and release PAIR again. You must press
PAIR while the MUTE light is still flashing. (The light flashes
for about seven seconds. If the light stops flashing, start again
with step one above.)
Enter the following code on the headset by pressing the keys in
this order: VOLUME /+, MUTE, VOLUME /–, MUTE,
VOLUME /+, VOLUME /–, MUTE. When you see the MUTE
light on the headset base turn off and the headset(s) ON/OFF
light flashes twice every five seconds, the deregistration is
successful. Repeat this step on the other headset if there is any.
4. To register the headset(s) to the headset base again, follow
the registration instructions on page 10.
NOTES:
If the deregistration process was not successful, you may need to reset
the system and try again. Remove the headset from the headset base and
press ON/OFF. Place the headset back into the headset base. You may
also reset by unplugging the power from the headset base, then waiting a
few seconds, and plugging it back in.
You cannot deregister the headset(s) if another system headset is in use.
1.
2.
3.
•
•
Operation