Filter
Top Products
21
Operation
Headset operation
Temporary ring tone silencing
Press MUTE/FLASH to temporarily silence the ring tone in
the headset earpiece. This silences the ring tone without
disconnecting the call. The next incoming call rings normally at
the preset volume.
NOTE: If you have more than one headset registered to the headset base,
both headsets receive the ring tone when there is an incoming call.
Pressing MUTE/FLASH on one headset will only silence the ring tone of that
particular headset.
Intercom calls and transfers
If you have registered your headset to an AT&T DECT cordless
telephone, follow the instructions in your telephone user’s
manual for intercom calls and transfers.
When the cordless handset prompts you to enter a handset number:
If you have 1 registered handset, press # (pound key) on the
cordless handset.
If you have 2 registered handsets, press #1 for headset 1 and
#2 for headset 2.
NOTE: You can only make intercom calls or transfers from an AT&T DECT
cordless handset to the DECT cordless headset.
•
•