Filter
Top Products
10
Getting started
Registering the headset
To register a headset to a TL7610/TL7611/TL7612 DECT
headset base
Make sure the battery is properly installed
in the headset (see page 7). The ON/OFF
light flashes twice every five seconds to
indicate the headset is not registered.
Place the headset in the headset base or
charger and allow it to charge for at least
five minutes before beginning registration.
Remove the headset from the headset
base or charger.
On the headset base, press and hold
the PAIR button until the MUTE light on
the headset base turns on (about four
seconds) and release the button.
Return the headset to the headset base
for registration.
Registration may take about 30 seconds to complete. The MUTE
light on the headset base turns off. The headset ON/OFF light
turns blue on the first headset registered and orange on the
second headset registered.
To verify registration was successful, press the headset ON/OFF
button and check for a dial tone.
If the registration was not successful, the ON/OFF light on the
headset flashes twice every five seconds. To reset the headset,
remove the headset from the headset charger and try the
registration process again.
1.
2.
3.
4.
5.