67
Answering system
Message counter displays
The message counter usually displays the total
number of answering system messages. See the
table below for other message counter displays.
Message counter displays
0
No messages.
0
(flashing)
The clock needs to be set (pages 55-56).
1-99
Total number of old messages and
memos, or message number currently
playing.
1-99
(flashing) Total number of messages and memos.
The number flashes when there are new
(unreviewed) messages.
After a power failure, the number in the
message counter will flash to indicate the
clock needs to be set.
10-99
Current remote access code while setting
(page 62).
1-99
(counting) Elapsed time while recording a memo
(page 66) or announcement up to 90
seconds (page 58).
99
(flashing) A memo recording is longer than 99
seconds.
1-99
&
F
Memory is full. Messages must be
(alternating) deleted before new messages can be
recorded.
--
The system is answering a call, being
accessed remotely, or the clock is being
set.
--
(flashing) The system is being setup, initialized or
messages are being deleted.
02, 04, 06, Displayed while setting the number of
rings (page 61).
1-8
Displayed for two seconds while
adjusting the telephone base speaker
volume.
HI, LO, OF
Displayed for two seconds while
adjusting the telephone base ringer
volume.
tS