Filter
Top Products
55
Answering system
Day & time announcement
Before playing each message, the answering
system announces the day and time the message
was received.
If you subscribe to caller ID service from
your local telephone company, the time will
automatically be set with every incoming call. You
must set the year so that the day of the week can
be calculated from the caller ID information.
To check day & time
You can press CLOCK when the system is idle to
hear the current day and time.
If you do not hear the correct year, time and day,
follow the steps below.
To set day & time
Follow the steps below to set the year, time and
day, so the day and time are correct. Each time
you press SKIP or REPEAT, the year, hour,
minute or day is adjusted by one increment.
Press and hold SKIP or REPEAT to adjust the
minutes or year by increments of ten. When you
hear the correct setting, press CLOCK to move to
the next setting.
1. Press CLOCK. The system will announce the
current clock setting, and then announce “To
set the clock, press CLOCK.”
2. Press CLOCK. The system will announce the
current year setting, and then announce “To
change the year, press SKIP or REPEAT. To
change the hour, press CLOCK.”
3. Press CLOCK. The system will announce the
current hour setting, and then announce “To
change the hour, press SKIP or REPEAT. To
change the minute, press CLOCK.”
4. Press CLOCK. The system will announce the
current minute setting, and then announce “To
change the minute, press SKIP or REPEAT. To
change the day, press CLOCK.”
NOTE: If the clock is
not set when a
message is recorded,
the system will
announce, "Time and
day not set" before the
message is played.