Filter
Top Products
Bluetooth
20
Bluetooth setup
Manual connection
To manually re-connect a paired device, make
sure the Bluetooth feature is turned on in your
cellular phone, select AT&T DECT 6.0 from the
paired device list in your cellular phone. Once the
connection is established again, the Bluetooth
button on the telephone base will turn back on.
Turning off the auto connection
If you do not want the telephone base to
re-connect to a paired device automatically after
it is disconnected, you can turn off the auto
connection feature manually. While a paired
device is connected to the telephone base, enter
the paired device list in the cellular phone and
disconnect the device from the telephone base;
refer to the user's manual of your cellular phone
for instructions. The telephone base will not search
and re-connect to that paired device until this
feature is activated again.
To resume the auto connection between the
paired device and the telephone base, make
sure the Bluetooth feature is turned on in your
cellular phone, select AT&T DECT 6.0 from the
paired device list in your cellular phone. The auto
connection will then be established again.
Replace a paired device
If you want to pair and connect a new device when
there is already a device paired with the telephone
base, press and hold the Bluetooth button on the
telephone base until it is flashing, then start with
step two of Pairing a device on page 19. If you
do not pair a new device within two minutes, the
Bluetooth light on the telephone base will turn off
and the system will return to idle mode.