Filter
Top Products
62
Telephone settings
Answering system settings
Number of rings
When the answering system is turned on, it answers all incoming calls on
line 1 and line 2 after the number of rings set. You can choose from two,
four, or six rings; or toll saver. With toll saver selected, the answering
system answers after two rings when you have new messages, and after
four rings when you have no new messages. This enables you to check for
new messages and avoid paying unnecessary long distance
charges if you are calling from out of your local area.
To set the number of rings:
Using a cordless handset:
Press the MENU softkey on the handset in idle mode to
enter the main menu.
Press or to scroll to ANSWERING SYS, then press
the SELECT softkey.
Press or to choose Mailbox 1 or Mailbox 2, then
press the SELECT softkey.
Press or to highlight Ans sys setup, then press the
SELECT softkey.
Press the SELECT softkey again to select # of rings.
Press or to choose 6, 4, 2 or Toll saver, then press
the SET softkey. You hear a confirmation tone.
Using the telephone base:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press DIR, CID, /DELETE or
/REC
to highlight
Answering sys, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to choose
Mailbox 1 or Mailbox 2, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Ans sys setup, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
# of rings, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to choose
6, 4, 2 or Toll saver, then press the SET softkey. You
hear a confirmation tone.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
ANSWERING SYS
Mailbox 1
Mailbox 2
BACK SELECT
# OF RINGS
6
4
2
BACK SET
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
BACK SELECT
ANSWERING SYS
Mailbox 1
Mailbox 2
SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
SELECT
# OF RINGS
6
4
2
RECORD SET
ANS SYS SETUP
Call screening
# of rings
Remote code
REC SELECT