Filter
Top Products
20
Bluetooth
Bluetooth setup
Paired devices
All paired devices are stored on the paired devices list. Up to four devices
(cell phones and headsets) can be paired with the telephone base.
To use a paired device, it must be on the active devices list (page 22)
and connected.
Once you have paired a device to the telephone base, you do not need to
repeat the pairing procedure again unless you delete the device from the
paired devices list.
NOTE: Only the first 15 characters of the device name are shown on the paired
devices list.
Rename a paired device
You can change the name of a paired device on the paired devices list.
Press the MENU softkey on the telephone base in
idle mode.
Press DIR, CID, /DELETE or
/REC
to highlight
Bluetooth, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Paired devices, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight a
device when necessary, then press the
OPTION softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Rename, then press the SELECT softkey. The screen
displays ENTER NEW NAME.
Use the dialing keys to edit the name (page 95).
Press CANCEL to erase a character.
Press DIR or /SKIP to move the cursor to the
right. Press CID or /REPEAT to move to the left.
Press the SAVE softkey to confirm. The telephone base
displays Device renamed.
If the name you try to save already exists, the
telephone base displays Device name already exists. Rename device?
Press the YES softkey to rename your device.
1.
2.
3.
4.
5.
6.
•
•
7.
•
PAIRED DEVICES
Disconnect
Rename
Remove paired
BACK SELECT
Answering sys
Directory
Call log
Bluetooth
SELECT
BLUETOOTH
Add headset
Active devices
Paired devices
SELECT
PAIRED DEVICES
Headset A
Cell phone A
Bluetooth
INFO OPTION
ENTER NEW NAME
SELECT
Headset A _
NEXT
BACK SAVE