Filter
Top Products
50
Telephone settings
Telephone base settings
Cell area code
If you have downloaded a directory from your cell phone, you may need
to set your cell area code in order to dial a number from your downloaded
directory correctly.
Most cell phone entries are stored in a 10-digit format. If all of your cell
phone entries are stored this way, you do not need to program your cell
area code.
If your cell phone stores entries in a 7-digit format, we recommend that you
program your cell area code so that your 7-digit directory entries can be
dialed correctly using your land lines.
To set the cell area code:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press DIR, CID, /DELETE or
/REC
to highlight
Directory, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight a
desired downloaded directory, then press the
SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Cell area code, then press the SELECT softkey.
Use the dialing keys to enter the desired cell area code.
Press CANCEL to erase a digit.
Press DIR or /SKIP to move the cursor to the
right. Press CID or /REPEAT to move to the left.
Press the SET softkey to confirm. You hear a
confirmation tone.
NOTE: If, in the future, your telephone service provider requires you to dial 10 digits
to make a local call (area code + telephone number), or, if you move to a location that
requires it, delete your cell area code you have already programmed following the steps
above. After you have deleted the cell area code, _ _ _ appears on the telephone base.
1.
2.
3.
4.
5.
•
•
6.
DIRECTORY
Home
Cell phone A
Cell phone B
SELECT
CELL AREA CODE
On
---
SET
CELL PHONE A
Review
Cell area code
Last update
SELECT
Play messages
Answering sys
Directory
Call log
SELECT