AT&T CL4940 Telephone User Manual


 
4
Getting started
Install the telephone as shown below.
The telephone is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 6 for details.
Telephone installation
Plug one end of the coiled handset cord into the handset jack on the left
side of the telephone base. Plug the other end into the jack on the bottom
of the handset.
1.
Plug one end of the telephone line cord into the telephone line jack on the
bottom of the telephone base. Route the telephone line cord through the
slot. Plug the other end of the telephone line cord into a telephone wall
jack or a DSL filter.
Plug the small end of the power adapter into the power jack on the bottom
of the telephone base. Route the power adapter cord through the slot. Plug
the large end into an electrical outlet not controlled by a wall switch.
2.
3.
DSL filter (not included)
is required if you
have DSL high-speed
Internet service.
Telephone wall jack
Electrical outlet
not controlled by
a wall switch
Route the power adapter
cord and the telephone
line cord through the slots.