AT&T CL4940 Telephone User Manual


 
7
Getting started
Installation options
Plug one end of the telephone line cord into the telephone line jack on
the bottom of the telephone base. Plug the other end into a telephone
wall jack or a DSL filter. Bundle the telephone line cord and secure it with
a twist tie.
Plug the small end of the power adapter into the power jack on the bottom
of the telephone base. Route the power adapter cord through the slot. Plug
the large end into an electrical outlet not controlled by a wall switch.
3.
4.
Place the telephone just above the studs on the wall mounting plate. Slide
the telephone down until it is held securely on the wall mounting plate.
Place the handset on the telephone base.
5.
Adjust the screen angle for maximum visibility. 6.
DSL filter (not included)
is required if you
have DSL high-speed
Internet service.
Telephone wall jack
Electrical outlet
not controlled by
a wall switch
Route the power adapter cord
through the slot.