Filter
Top Products
Modular
Telephone Jack
Lines 3 and 4
Modular
Telephone Jack
Lines 1 and 2
Standard
Electrical
Outlet
Power Cord
13
INSTALLATION
9 Plug the power adapter into a standard electrical outlet not
controlled by a wall switch.
10 Initialization.
As soon as you connect the power cord, the system runs a quick
self-test and the screen displays Initializing for about seven
seconds. When the test is complete, the system enters an initial
setup mode (this happens the first time you plug in the unit only)
and the screen displays press PROG to setup your phone.
See SET UP SYSTEM FEATURES beginning on page 15.
12
5 Connect the handset cord.
Plug one end of the coiled handset cord into the jack on the
left side of the phone. Plug the other end into the handset, and
hang up.
6 Connect the power adapter to the telephone.
Use only the power adapter provided with this product. To obtain
a replacement, call 1 800 222–3111.
Plug one end of the power adapter into the jack labeled ADAPTER
on the back of the phone.
NOTE: If the screen displays POWERFAIL the first time you plug in the
phone, press any key to clear the screen.
7 Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial
tone, turn to IN CASE OF DIFFICULTY.
8 Mount the phone on the wall
• Four One-Line Jacks
INSTALLATION
• Two Two-Line Jacks
Modular
Telephone Jacks
Lines 3 and 4
Modular Telephone Jacks
Lines 1 and 2
Standard
Electrical
Outlet
Power Cord