Filter
Top Products
SET UP SYSTEM FEATURES
21
SET UP SYSTEM FEATURES
20
Turn Hold Reminder On or Off
1 Press G.
2 Press - until the screen displays HOLD REMINDER, then press >.
3 Press - or + to select the desired setting.
4 Press S to store your selection.
Program Home and Local Area Codes
One Home and up to five Local Area Codes can be programmed into the
unit. The Home Area Code must be programmed in order for you to dial
numbers stored in the directory and the Caller ID Call List and so that you
can transfer numbers from the Call List to the directory. By programming
these specific area codes, the unit will be able to distinguish a local call from
a long distance call, and will thereby dial the appropriate number of digits.
1 Press G.
2 Press - until the screen displays AREA CODEs, then press >.
3 Press - or + to select type of area code you wish to set.
4 Press > to confirm your choice, then use the keypad to enter the
digits of the area code.
5 Press S to store the setting.
6 Repeat Steps 1-5 to program additional area codes.
NOTE: If you must dial the area code to place calls within your own
area code, enter “000” for the Home Area Code and enter your area code
as a Local Area Code.
You will need to program the following two features if this phone
is the designated Console Phone for your Centrex system:
Set Your Phone to be the Centrex Console Phone
NOTE: This feature is for use with Centrex systems only.
1 Press G.
2 Press - until the screen displays CONSOLE, then press >.
3 Press - or + to select a setting.
4 Press S to confirm your selection.
Program the Centrex Console Delayed Ring Time
NOTE: This feature is for use with Centrex systems only.
Set the length of time the phone will ring before the Centrex Console
phone picks up calls to your phone. One ring is about six seconds.
1 Press G.
2 Press - until the screen displays CSL DELAY RING, then
press >.
3 Press - or + to select a setting.
4 Press S to confirm your selection.
Erase All Settings and Return the Phone to Default
Settings
1 Press G.
2 Press - until the screen displays RESET ALL?.
3 Press >. The screen displays:
4 Press R within three seconds to confirm the RESET ALL
command. The screen displays: