Filter
Top Products
1 If the announcement you want to record is the currently selected
announcement (A, B, or AO) go to Step 2. If not, select the
announcement by following the instructions in “Select Your
Announcement” on page 11, then go to Step 2 below.
2 Press c on the base.
3 Press A.
4 At the prompt, begin recording your announcement. Your
announcement can be up to three minutes long. Speak in a
normal tone of voice, about nine inches from the microphone.
5 When you are finished, press X or x. If the
announcement did not record successfully, you’ll hear an error
tone. Record the announcement again.
To review the announcement at any time, press A.
NOTE: The total recording time for this system is about 20 minutes.
Since all messages, memos, and announcements contribute to that time,
a short outgoing announcement is recommended.
Delete an Announcement
1 If the announcement you want to delete is the currently selected
announcement (A, B, or AO) go to Step 2. If not, select the
announcement by following the instructions in “Select Your
Announcement” on page 11, then go to Step 2 below.
2 Press A on the base.
3 Press D while the announcement is playing. The system
beeps once when the announcement is deleted.
Set the Clock
1 Press c. The Message Window displays CH.
2 Press C. The system announces the current day setting. To
change the day setting, hold down < or > until the
correct day is announced. Then release the button.
3 Press C. The system announces the current hour setting. To
change the hour setting, hold down < or > until the
correct hour is announced. Then release the button.
4 Press C. The system announces the current minutes setting.
To change the minutes setting, hold down < or >
until the correct minutes are announced. Then release the button.
8 Press C. The system announces the new day and time.
To check the current clock setting at any time, press C.
FEATURE SETUP
13
FEATURE SETUP
9465 book_1ATT 2/29/00 11:23 PM Page 13