Filter
Top Products
FEATURE SETUP
8
Caller ID Feature Setup
You can continue to set up Caller ID features directly after setting up the final
Telephone feature (Handset Ringer), by programming your Home Area Code.
1 Make sure the phone is off ( is not
displayed).
2 Press U, then >, and use the softkey to
select SETUP.
3 Select DONE if needed to reach the feature
you want to set, then use the CHANGE
softkey to scroll through the options for
that feature.
4 Select DONE again when the desired choice
is displayed to save your selection and
move to the next feature. When you have
finished setting Caller ID features, press
U to exit.
Program Home and Local Area Codes
Your “home area code” is the area code from which you are dialing.
“Local area codes” are area codes for which you must dial an area code but
not “1.”
Always program your home area code, and, if you need them, up to four
local area codes to allow for correct operation of the Display Dial feature
(see page 40).
NOTE: Do not select CHANGE. Instead, when screen displays AREA
CODE 1:
1 Use the keypad to enter your home area
code (AREA CODE 1).
2 Select CODE 2 to reach AREA CODE 2 (the
screen displays any current local area code
stored here). Use the keypad to enter a
three-digit local area code.
3 Continue as in Step 1 for area codes 3, 4
and 5 as needed.
4 Select DONE when finished.
AREA CODE 1:000
CODE 2 DONE
FEATURE SETUP
9465 book_1ATT 2/29/00 11:23 PM Page 8