Filter
Top Products
Speakerphone
To make a call, press and release the desired LINE
button or K. The SPEAKER light goes on. Wait
for a dial tone, then dial the call. Press K to end
the call.
To answer a call, press K or press the LINE
button of the incoming call. Press K again to
end the call.
NOTE: If headset is programmed as the default mode
(see “Set Automatic Mode” on page 31), you must
press K to activate the speakerphone.
Headset
You can use this phone hands-free when you install any
AT&T two-band 2.5 mm headset or other compatible,
electronically isolated headset. The headsets must be
purchased separately. Headsets are available by calling
Customer Service at 1 800 222–3111. For best
results use an AT&T two-band 2.5 mm headset.
Make sure the headset is plugged into the headset jack.
You will hear a double-beep if you press h when
the headset is not plugged in.
NOTE: If headset is programmed as the default mode,
(see “Set Automatic Mode” on page 31) but the
headset is not plugged in, the phone will switch to
speakerphone.
To make a call, press and release h or press
the desired LINE button and then press h.
The HEADSET light turns on. Wait for a dial tone,
then dial the call. Press h to end the call.
To answer a call, press h. Press h
again to end the call.
NOTE: If speakerphone is programmed as the default
mode (See “Set Automatic Mode” on page 31), you
must press h to activate the headset.
39
TELEPHONE OPERATION
TELEPHONE OPERATION
❖
❖❖
❖❖
▼
▼▼
▼▼▼
▼▼
▼▼▼
▼▼
▼▼▼
▼▼
▼▼
❖
❖❖
❖❖
▼
▼▼
▼▼▼
▼▼
▼▼▼
▼▼
▼▼▼
▼▼
▼▼
945 CIB 2ATT 3/14/05 9:58 AM Page 39