Filter
Top Products
1
BEFORE YOU BEGIN
BEFORE YOU BEGIN
BEFORE YOU BEGIN
Parts List
Your box should include:
This User’s
Manual
Quick
Start
Guide
NiCd
battery pack
Base Unit
INSTALLATION
Table/Desk Installation
NOTE: Install this telephone away from
electronic equipment, such as personal
computers, television
sets or microwave ovens. Avoid excessive heat,
cold, dust or moisture.
1 Connect the telephone line cord.(figure a)
2 Connect the power cord to the base and
an electrical outlet not controlled by a wall
switch.(figure a) The ANSWER ON/OFF light
goes on,and CLflashes in the message window.
Use only the power cord supplied with this product.
If you need a replacement,call 1 800 222–3111.
3 Install the handset battery. Use only AT&T
Battery 3301, SKU# 91076. (figure b)
4 Charge the handset battery.
•Place the handset in the base.
•Charge the battery at least 12 hours.
After the first charge,the batter y will
charge in eight hours.
5 Check for dial tone.
• After the batteries are charged, lift the
handset and press P;you should
hear a dial tone.
For detailed instructions for wall installation,to
remove the belt clip,or use a headset with this phone
please refer to the INSTALLATIONsection of your
User’s Manual
.
NOTE: If you have purchased the AT&T 2365,
you must place the fully charged 2300
Expansion Headset into your 2365 base for
registration. Refer to your 2300 User’s Manual
for more etials.
QUICK START GUIDE
2.4 GHz Cordless Telephone
2325/2365 with Caller ID/Call Waiting
b) Plug the battery pack
connector into handset.
Place the battery pack and
wires in the compartment.
a) Remove batter y
compartment cover by
pressing on indentation
and sliding downward.
c) Replace cover by
sliding it on its
track up over
battery case until
it snaps firmly
into place.
Standard
electrical
outlet
Power CordLine Cord
figure b
figure a
Modular
telephone
jack
Handset
Please also read
Part 1 — Important
Product Information
USER’S MANUAL
Part 2
© 2002 Advanced American Telephones.All rights reserved.
AT&T and the Globe Design are trademarks of AT&T Corp.licensed to Advanced American Telephones.
2.4 GHz Cordless Telephone
Answering System 2325/2365
with Caller ID/Call Waiting
2 Telephone
line cord
Power
adapter
Answering System 2325/2365
Remote Commands
To connect with your answering system:
1 Dial your telephone number from a touch tone phone.
2 When the system answers enter your Remote Access
Code (preset to 50).
3 Within 10 seconds, enter a remote command from inside
this card.
Wallet
Card
NOTE: If you have purchased the AT&T 2365, please also refer to
the parts list in your AT&T 2300 User’s Manual.