Filter
Top Products
Section 4 User Interface Guide Total Access 600 Series System Manual
176 © 2004 ADTRAN, Inc. 61200624L1-1B
.
2. Configuring the Layer 2 Protocol
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 ATM Network Interface Protocol menus beginning on page 101
Layer 2 Protocol (ATM) Configuration – T1 Interface
Step Action
1
From the main menu, select L2 P
ROTOCOL
and press <E
NTER
>.
2
Use the arrow keys to select the P
ROTOCOL
field for the T1 interface. Press
<E
NTER
>. Select ATM from the list of available protocols.
3
Use the arrow keys to select the C
ONFIG
menu for the T1 interface and press
<E
NTER
>.
4
Highlight the ATM C
ONFIG
menu for the T1 interface and press <E
NTER
>.
5
Enter the I
DLE
C
ELLS
format for your network.
6
Set D
ATA
S
CRAMBLING
appropriately for your network.
7
Back all the way out to one level to the PVC C
ONFIG
menu, and press <E
NTER
>.
Enter the VPI and VCI values for communicating with that Gateway. Select
R
OUTER
under the C
ONNECTION
field.
8
Select the S
ETUP
menu and configure the virtual circuit for IP or PPP operation.
(Our example selects IP.) Refer to
L2 Protocol (ATM–NET–ATM) > Config >
PVC Config > Setup (Router) on page 103
for more details.
9
Set mode to R
OUTE
IP. Using this menu you also have the option to route only
IP packets and bridge all other data packets (R
OUTE
IP/B
RIDGE
O
THER
) or
bridge all data packets on this connection (B
RIDGE
A
LL
). Refer to
L2 Protocol
(ATM–NET–ATM) > Config > PVC Config > Setup (Router) on page 103
for
more details.
10
Left arrow back to the main menu to save the changes.