ADTRAN 624 Telephone User Manual


 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 143
SECURITY > FILTERS > FILTER DEFINES > PATTERN FILTER DEFINES
The pattern filter is applied to bridge packets only. That is any packet which is forwarded by the bridge
functionality of the unit. Up to 32 pattern defines can be specified.
SECURITY > FILTERS > FILTER DEFINES > IP FILTER DEFINES
The IP filter defines apply to any IP packet, whether it is routed or bridged. Up to 32 IP defines can be
specified.
T
YPE
16-bit type field used for comparison. Values are in hexadecimal format. Default is 00:00.
T
YPE
M
ASK
Bits in the type field used for comparison. Values are in hexadecimal format. Default is
00:00
.
N
UM
Indicates the entry number in the Pattern Filter Defines table.
N
AME
Identifies the filter entry. Default is no entry in N
AME
field.
F
ILTER
T
YPE
Specifies a N
ORMAL
or D
EBUG
filter. When a N
ORMAL
filer is applied to an interface, traffic is blocked
or forwarded according to the filter. When a
D
EBUG
filter is applied, packets that match the filter are
documented without affecting traffic flow. (Use the
D
EBUG
filter with the Syslog or Terminal Mode
logging to view the packet contents.)
O
FFSET
Offset from beginning of packet of where to start the pattern comparison. Default is 0.
P
ATTERN
64 bits used for comparison. Values are in hexadecimal format. Default is 00:00:00:00:00:00:00:00.
M
ASK
Bits in the pattern to be compared. Values are in hexadecimal format. Default is
00:00:00:00:00:00:00:00.
N
UM
Indicates the entry number in the IP Filter Defines table.