Filter
Top Products
Total Access 600 Series System Manual Section 5 DLP-19
61200624L1-1B © 2004 ADTRAN, Inc. 241
9. Factory default the Total Access 612/616/624 by one of the following methods:
• Select S
YSTEM
U
TILITY
> T
ERMINAL
M
ODE
. At the > prompt, type factory_reset. You will then see
“Restore Factory Defaults and Reset Unit? (press
Y).” Press the Y key to confirm default. The unit
then resets.
• If connected to the
CRAFT port (must be 9600 baud), power reset the unit and then restore power
to the unit while holding down the
F
key. You will then be prompted to confirm the factory default.
10. In the ATM code, the upgrade was successful if the S
YSTEM
I
NFO
> F
IRMWARE
R
EVISION
field does not
display Error.
11. Reconfigure the unit for the specific application.
Purchase of a T1 TDM 612/616/624 Unit with the EC/ADPCM Card Installed for Later Upgrade to ATM
For customers who plan to operate a TDM application initially, but eventually upgrade to an ATM
application, a Total Access 612/616/624 unit may be purchased with the EC/ADPCM card installed
(P/N 4200612L2#TDM, 4200616L2#TDM, 4200642L2#TDM).
1. When the circuit is converted to ATM, the customer may obtain the latest VoATM firmware from the
ADTRAN website (http://www.ADTRAN.com). Select S
UPPORT
> P
OST
-S
ALES
T
ECHNICAL
S
UPPORT
>
F
IRMWARE
U
PDATES
> 612/616/624 ATM or contact Post-Sales Technical Support at 888-4ADTRAN.
2. Upgrade the Total Access 612/616/624 with the latest VoATM firmware (see Updating the Firmware
using TFTP and DLP-8, Updating the Firmware using XMODEM for details on upgrading the
firmware).
3. Factory default the Total Access 612/616/624 by one of the following methods:
• Select S
YSTEM
U
TILITY
> T
ERMINAL
M
ODE
. At the > prompt, type fac. You will then see “Restore
Factory Defaults and Reset Unit? (press
Y).” Press the Y key to confirm default. The unit then resets.
• If connected to the
CRAFT port, power reset the unit and then restore power to the unit while
holding down the
F key. You will then be prompted to confirm the factory default.
4. In the ATM code, the upgrade was successful if the following two things occur:
•The S
YSTEM
I
NFO
> F
IRMWARE
R
EVISION
field does not display Error.