Filter
Top Products
Installation
Getting Started
Unpack the unit and check to make sure you have all the
items that come with your telephone.
•
AT-200HT headset telephone.
•
Headset with cord.
•
7 foot long telephone line cord.
•
Belt Clip
Battery Installation
The AT-200HT requires the installation of four AAA size, 1.5 volt
alkaline batteries (not included). If batteries have not been in-
stalled, or require replacement, Caller-ID information will not be
displayed.
WARNING: Always disconnect the AT-200HT from the tele-
phone line before inserting or replacing batteries.
1. Remove the battery cover.
2. Use a ball point pen tip or similar object to lift the battery cover
up and away from the cabinet. See Figure 1
3. Install four AAA size alkaline batteries into the battery compart-
ment.
4. Take care to insure that each battery is installed with the cor-
rect polarity. Reinstall the battery cover.
5. The
NEW CALL
LED will light and the display indicate
"70
CALLS"
briefly. Then the AT-200HT will go into setup
mode.
Important:
Proceed immediately to set the display lan-
guage and area code as required.
6