Filter
Top Products
4. Press and hold the
ERASE
button, then press the review
"#
button while in Stand-By Screen mode.
Installing the Belt Clip
A belt clip has been supplied with your headset telephone. It
can be easily installed or removed as required. See Figure 1
1. Insert the belt clip mounting tabs into the corresponding
mounting holes located on the rear surface of the unit.
2. Confirm the belt clip mounting tabs are aligned correctly.
3. Press the belt clip to the left to lock it in place.
Using the Headset
Your AT-200HT is supplied with a high quality headset to
provide clear voice communications. Its microphone boom can
be swiveled so the headset can be used on either ear. See
Figures 3 & 4
1. Plug from the headset cord into the modular jack marked
HEADSET
on the left side of the unit.
2. Place the headband on your head with the cushioned
speaker over the ear of your preference.
10