Filter
Top Products
25
Troubleshooting
No Dial Tone.
•
The telephone line cord is not plugged in properly at the
telephone jack or at the telephone.
•
Test the telephone using a different telephone jack, if it works,
the first jack may be defective.
Have Dial Tone but Cannot Dial Out.
•
Check that the
PULSE/T
ONE switch is set to the correct mode.
Display screen is blank.
•
Check if the batteries have been installed correctly.
•
The batteries need to be replaced.
Unable to Set Display Language.
•
"SET LANGUAGE"
is displayed for sixteen seconds after the bat-
teries are installed. If you have not completed the setup procedure,
the display will return to Stand-By Screen mode. Press and hold
the
ERASE
button, then press the review
"
button. The display
Language, or Area Code can now be programmed or changed.
Does not display Caller-ID information.
•
Confirm that your local telephone company has activated
Caller-ID service.
•
Caller-ID information is sent by the telephone company be-
tween the first and second rings. If the call is answered before
the second ring, the Caller-ID information may not be received
correctly.