Filter
Top Products
Chapter 3 Preparing the Cisco CallManager and Octel Systems
Configuring Cisco CallManager
3-6
Cisco Digital PBX Adapter 7630 Administration Guide
78-11069-01
Incoming Calls
The call ports supporting incoming calls require additional configuration in
Cisco CallManager. In these cases, these lines and their corresponding call ports
compose the voice mail hunt groups. See Figure 3-1 for an example of the
following settings:
• Directory Number—Assign a directory number to each of these phones.
These directory numbers establish the voice mail hunt group to be used by the
Cisco IP Phones.
Assign one of these ports to be the primary or “pilot” directory number in the
voice mail hunt group. Record this value because you need it to configure the
DPA 7630. In this example, the pilot directory number is 1500.
• Call waiting—You must disable it on these phones.
• Call forwarding—Assign call forwarding numbers (Forward Busy and
Forward No Answer settings), so calls roll to next available directory number
in the hunt group.
• Display—If the DPA 7630 is connected to an Octel 200 or 300 voice mail
system, you must enter D-xxxx, where xxxx is the directory number. In this
example, you would enter D-1502. However, you do not need to enter
anything in the Display field if the DPA 7630 is connected to an Octel 250 or
350 voice mail system.