Filter
Top Products
Chapter 3 Preparing the Cisco CallManager and Octel Systems
Configuring Cisco CallManager
3-2
Cisco Digital PBX Adapter 7630 Administration Guide
78-11069-01
Configuring Cisco CallManager
The DPA requires minor changes to Cisco CallManager because when you add
the DPA 7630 to the IP network, Cisco CallManager recognizes the ports as Cisco
IP Phones. Therefore, you need to add these ports to the Cisco CallManager
database.
The DPA 7630 connects to Cisco CallManager to provide the following
capabilities:
• Access from the Cisco IP Phones to the voice messaging system on the Octel
systems.
The DPA 7630 provides connection to the Octel voice messaging system by
emulating IP phones. These emulated phones appear in the
Cisco CallManager database.
Table 3-1 System Setup Checklist
Task For More Information
Cisco CallManager Configuration
Add the DPA 7630 to the Cisco CallManager
database manually or using auto-registration.
See “Adding the DPA 7630 to
Cisco CallManager” section on page 3-3.
Configure the ports from the DPA 7630 as
Cisco IP Phones in the Cisco CallManager
database.
See “Configuring the DPA Ports and Phones”
section on page 3-5
Verify that the options for enabling and
disabling MWI on the Cisco IP Phones are
configured in Cisco CallManager.
See “Enabling the Message Waiting Light”
section on page 3-10.
Verify that the voice mail hunt group is set up
properly.
See “Setting Up the Voice Mail Hunt Group”
section on page 3-11.
Octel Configuration
Set dialing sequence for message waiting
indicator.
See the “Setting Dialing Sequence for Message
Waiting Indicator” section on page 3-14.
Assign lines to handle incoming calls,
outgoing calls, and MWI commands.
See the “Assigning Incoming, Outgoing, and
MWI Lines” section on page 3-14.