ZyXEL Communications V500-T1 IP Phone User Manual


 
ENGLISH
7
1.2 Rear Panel Hardware Connections
1WAN: Use an Ethernet cable to connect the V500 to your network.
V501-T1 only: If you are using Power over Ethernet (PoE), connect the Ethernet cable
supplying power to this port. See Section 1.3 on page 8 for more information on PoE.
2PC (optional): Use an Ethernet cable to connect your computer to the PC port on the
V500 to access your network through the V500, or to configure the V500 using the web
configurator (see your User’s Guide for information on using the web configurator).
3 HANDSET: Connect the included handset cable to the HANDSET port on the V500.
Connect the other end to the handset. Hang up the receiver before you connect the
power.
4POWER: Connect the included power adaptor to the POWER socket on the V500. Plug
the power adapter into an appropriate power source.
V501-T1 only: If you are using Power over Ethernet (PoE), you do not need to connect the
power adaptor.