Filter
Top Products
Prestige 2000W_V2 User’s Guide
100 Chapter 13 Administrator Web Configurator Screens
Table 20 PHONE
LABEL DESCRIPTION
Default Voice Codec A voice codec (coder/decoder) converts voice data to electrical signals
for transmission over a network.
Use this field to select the type of voice coder/decoder (codec) that you
want the Prestige to use. Choosing a voice codec depends on a tradeoff
between transmission speed, sound quality and desired bandwidth
usage. G.711 provides higher voice quality than G.729 but requires
64kbps of bandwidth while G.729 only requires 8kbps. The Prestige can
only connect to other phones that use the same codec as the Prestige.
If you want to use G.711, G.711u is used mainly in North America and
G.711a is used in most of the rest of the world.
Speaking Volume(-14~14) Select the default gain for the Prestige’s microphone, where –14 is the
minimum (least sensitive) and 14 is the maximum (most responsive).
The callee may hear an echo if you set the microphone’s volume to the
maximum.
Listening Volume(-14~14) Select the default speaker volume on the Prestige, where –14 is the
minimum (quietest) and 14 is the maximum (loudest).
RTP Port Real time Transport Protocol is used to handle voice data transfer. Use
this field to configure the Prestige’s listening port for RTP traffic. Leave
this field set to the defaults if you were not given a RTP port to use.
Jitter Buffer A larger receiving buffer allows the Prestige to rearrange data packets
that arrive in the wrong order.
Packets are dropped if they arrive out of order and the receiving buffer
is full.
Increasing the buffer size introduces latency. Too large and a significant
delay could be introduced over a slow connection, too small and the
signal may distort.
Voice Frames per Packet Use smaller packet sizes to reduce the number of speech frames sent
per packet. If a small packet does not reach its destination is it less
significant than if the packet contained many speech frames.
DTMF Relay Dual Tone Multi-Frequency signals are generated when you press a key
on the Keypad and communicate information (such as telephone
numbers) to the VoIP gateway.
Select disable to send the DTMF digits uncompressed from the
remaining protocols to use a compression method to match that of your
ITSP’s.
Select Inband(RFC 2833) to send the DTMF tones in RTP packets.
Select Outband to send the DTMF tones in SIP messages.
DTMF Payload (0-127) This field allows you to set the DTMF payload type. It is recommended
to leave the default setting for this field.
APPLY Click APPLY to save your changes without restarting the Prestige. Your
wireless LAN, Internet and SIP settings changes do not take affect until
you use RESTART (in the navigation panel).
CANCEL Click CANCEL to begin configuring this screen afresh.