Filter
Top Products
BASE
UNIT
FEATURES
BASE UNIT FUNCTION KEYS
POWER lndicator
Glows when the power supply is
plugged in and power is applied to the
Base Unit.
HS IN-USE lndicator
Glows when the Handset has been
activated.
CHARGING lndicator
Glows when the Handset is placed in
the Base Unit cradle. If there is no
battery pack in the Handset, the
CHARGING LED
will flash slowly.
SPARE BATT lndicator
Glows when an optional battery pack
is installed in the Base Unit charger.
HOLD lndicator
Glows when an active call is placed on
HOLD.
MUTE lndicator
Glows when the Base Unit
MUTE
key
is pressed during an active call.
INT.COM lndicator
Glows when the Base Unit is in
INTERCOM
mode with the Handset.
SPEAKERPHONE (SP PHONE)
lndicator
Glows when the Base Unit
Speakerphone is active.
Flashes slowly to indicate that an
extension phone is in use.
Flashes in cadence with the incoming
ring.
Speakerphone (SP PHONE) Key
Press this key to either initiate or
answer a call from the Base Unit
Speaker. Press it again to terminate
your call.
Volume (VOL) Key
Press the appropriate key to raise or
lower the Speakerphone volume level.
Holding down the key will continuously
raise or lower the volume. There are
a total of
8
volume levels.
Base Ringer ONlOFF Switch
Located on the bottom of the Base Unit,
this switch controls the Base Unit
ringer. It has no affect on the Handset
ringer.
TONEIPULSE Switch
Located on the bottom of the Base Unit,
set this switch consistent with your
local phone system. In most cases, the
appropriate setting is
TONE(TT).
Memory (MEM) Key
Press this key to enter Memory (Speed)
Dialing Mode.
Quick Memory (Q.MEM) Key
Press this key to dial the contents of
memory location
#00.
The Base
speakerphone can be either ON or
OFF to use this feature.
REDIAL Key
Press this key to redial the last number
you dialed from the Base Unit. This
feature is independent of the Handset
redial feature.
HOLD Key
Press this key to place your
Speakerphone call on hold. Press
either
@m)or @-@to return
to the call.
With a Speakerphone call on
HOLD,
picking up an extension phone, or
activating the VT
1940
Handset will
turn the Speakerphone OFF.
FLASH Key
During a Speakerphone call, press this
key to flash the line. The feature is
commonly used in conjunction with
Call Waiting.
MUTE Key
Press this key to mute the Base Unit
microphone durin a Speakerphone
call. Press
(KEY
again to return to
the 2-way conversation.
Intercom (1NT.COM) Key
Press this key to page the Handset.
The Handset will ring
5
times. The
Handset user can respond by pressing
INT COM .
The Handset and Base Unit
7
have now entered 2-way INTERCOM
mode.
Press
(MI
to terminate INTER-
COM mode.
This feature is also useful as a Handset
locator in the event it is misplaced.