Filter
Top Products
13
12
GETTING STARTED
Charge the handset battery pack
before use. The battery pack recharges
automatically whenever the handset is
in the base unit. The batteries must
be charged for 16 hours before using
your phone for the first time.
Setting Up Your VTech VT 1922
Choose an area near an electrical
outlet and a telephone wall jack.
AC Power Adapter
Plug the AC power adapter into an
electrical outlet and the DC connector
to the back of the base unit.
CAUTION:
Use only CLASS 2 9V DC POWER
SUPPLY included with your phone.
Handset Ringer
The handset ringer is programmed ON
as the factory default setting. Refer
to PROGRAMMING THE RINGER on
page 24 for more information.
Setting the Tone/Pulse Switch
The TONE/PULSE switch is located
on the bottom of the base unit and is
factory set to TONE. If you have touch
tone service, do not change the switch
setting. If you have rotary (Pulse)
service, set the switch to PULSE.
Connect Telephone Line Cord
Plug one end of the telephone cord
into a wall jack and the other end into
the back of the Base Unit.
P
HS IN USE
DIGIT
A
CORDL
E
MEMORY DIALING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
CHARGE THE
HANDSET
BATTERY PACK
FOR 16 HOURS
BEFORE USING
TONE PULSE
SELECTION
REPLACING THE BATTERY PACK
Power Backup
When a Spare Battery pack is installed
in the Base Unit, the VTech VT 1922
uses this battery pack to provide
operational backup in case of a power
failure. If you have a fully charged
battery pack in the Spare Battery pack
charger and there is a power outage,
you will still be able to place and
receive calls for up to five hours.
Replacing a Drained Handset bat-
tery
The Spare battery pack can also be
used to replace a drained Handset
battery pack to ensure uninterrupted
use. Be sure to put the drained battery
pack in the Spare Battery charger for
recharging.
Please note that the Spare Battery
compartment charges at a slower rate
than a battery pack charging in the
Handset. It takes 24 hours to fully
charge a battery pack in the Spare
Battery charger.
The RBRC
TM
Seal
The RBRC Seal on the
battery indicates that VTech
Communications, INC. is
voluntarily participating in an industry
program to collect and recycle these
batteries at the end of their useful
lives,when taken out of service within
the United States and Canada.
The RBRC program provides a
convenient alternative to placing used
nickel-cadmium batteries into the trash
or municipal waste,which may be
illegal in your area.
VTech’s partnership with RBRC
makes it easy for you to drop off used
batteries at local retailers participating
in the RBRC program.
Please call 1-800-8-BATTERY
TM
for
information on Ni-Cd battery recycling
and disposal bans/restrictions in your
area.VTech’s involvement in this
program is part of its commitment to
protecting our environment and
conserving natural resources.
Remove the nickel-cadmium battery
pack by pressing on the lock knob and
sliding downward as mentioned on
this page.
RBRC is a registered trademark of
Rechargeable Battery Recycling
Corporation.
R
R
R
R
R
R
R
TELEPHONE
WALL JACK
AC
OUTLET
9V DC
TEL LINE