Filter
Top Products
27
26
This inserts a 2 second pause. A
" P " appears in the display to show
the pause. For longer pauses, press
HOLD two or more times. Each press
makes the pause 2 seconds longer
and is treated as a stored digit.
If your phone is connected to a PBX,
you can store the PBX access
number and a pause before the
phone number. For example, to
store 9-PAUSE-555-1234 in memory
location 08, do the following:
1. Press 9
2. Press HOLD
3. Dial 5551234
4. Press PROG
5. Enter 08
NOTE:
Stored numbers are retained in
memory even if the base loses its
power or the handset battery is
removed.
MEMORY DIALING
Dialing From Memory
• Press PHONE to get a line.
• Press MEM , you're prompted to
enter a speed dial location
number:
NOTE:
The ability to temporarily add memory
contents to digits already entered on
the display operates in the same way
for CID and speed dial memories.
In this way, long distance and area
codes (for example, 1503) can be
entered on the LCD and can preface
numbers recalled from CID memory
before dialing. This is important
because only the last 7 digits of any
number are displayed when dialing
from CID memory.
Changing Stored Numbers
To change or replace a stored number
simply enter the new number on the
display and store it in the memory
location you wish to change.
Deleting Stored Numbers
• Press MEM . The display will
change to "SPEED DIAL
LOCATION_ _".
• Enter memory location number
(01-20).
• Press CLEAR/DEL key. The
display will change to "LOCATION
XX DELETED".
• Press OFF to exit.
Storing Special Codes
To insert a pause in a phone number,
press HOLD at the appropriate point
when entering the number on the LCD.
MEMORY DIALING
• Enter a 2 digit location number
(01-20)
• The number stored in that location
will be displayed and immediately
dialed.
Or
• Beginning from the OFF mode,
press MEM followed by a 2 digit
location number (01-20).
• Press MEM again to exit memory
dial mode and leave the number
on the display.
• Note that if digits were on the
display prior to entering memory
dial mode, the contents of the
speed dial memory will be ap-
pended to those digits. For exam-
ple, if 1503 was on the LCD and
the contents of the memory
location is 6438981, then the
display would show the following
upon exiting memory dial mode:
Press PHONE , the number on
the display will be dialed after a 2
second pause.