Filter
Top Products
Check for a dial tone. After the
battery pack is charged, rotate the
Base Unit antenna to an upright
position. Pick up the Handset and
presscPHONE) "PHONE ON" will
appear on the
LCD,
and you will hear
a dial tone. If not, see 'IN CASE OF
DIFFICULTY' on page
34.
Fill in the telephone number card on
the base unit.
CAUTION:
1.
Never install telephone wiring
during a lightning storm.
2. Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3.
Never touch uninsulated telephone
wires or terminals unless the
telephone line has been
disconnected at the network
interface.
4. Use caution when installing or
modifying telephone lines.
dAW>'M
0
U
N,T
USING
i;JPS;;.pALLy
s.t,,-J,,$
ADAPTOR
,:,,~?;'-~:'!'~,i~,~~~~f~~~~~~
f3
1.
Position the wall mount bracket
on the base,
Line up the tabs on the wall mount
adaptor
with. the holes on the
bottom of the base (Figure
1).
Snap the wall,mount bracket firmly
in place.
i
I
2.
Mount the bhse on the wall.
Position the base so the mounting
studs will fit
illto the holes on the
bottom of the base. Position the
power cord to extend down the
wall the pho?e is to be mounted
on. Slide
the: base down on the
mounting
stups until it locks into
place.
I
I
3.
Connect the hephone line cord.
The telephoqe line cord has a
snap-in plug At each end. lnsert one
of the plugs !into the jack on the
bottom of the Ibase. Insert the other
end of the plug into the wall jack.
4.
Plug the AC adaptor into an
electrical outlet and the DC
connector into the power jack
located on the back of the Base
Unit
.
igure
1
Figure
2