Filter
Top Products
You cannot select TONE for one line
and PULSE for the other. Both will be
either TONE or PULSE.
CHARGE THE HANDSET BAlTERY
PACK BEFORE USE.
The battery pack recharges
automatically whenever the handset is
in the base unit. The batteries must
be charged for
24
hours before using
your phone for the first time.
Fill in the telephone number card on
the base unit. To remove the window,
insert the tip of a paper clip or pen into
the hole, and gently flex the window.
Check for a dial tone. After the
batteries are charged, pick up the
handset. Now press
LlNE
1
on the
handset. The LlNE
1
indicator should
light up on the LCD, and you should
hear a dial tone.
If not, see 'IN CASE
OF DIFFICULTY' on page 30.
CAUTION:
1.
Never install telephone wiring
during a lightning storm.
2. Never install telephone jacks in wet
locations unless the jack is
specifically designed for wet
locations.
3. Never touch uninsulated telephone
wires or terminals unless the
telephone line has been
disconnected at the network
interface.
4.
Use caution when installing or
modifying telephone lines.
WALL INSTALLATION USING
MOUNTING SCREWS PROVIDED
Tools You Will Need:
A
hammer, a
nail, a pencil or ballpoint pen, a Phillips
head
(+)
screwdriver, and the Wall
Mounting Template included in the
back of this booklet.
1.
Choose a spot near an electrical
outlet and a telephone jack.
Your phone requires a modular
telephone jack and a standard
electrical outlet (120v AC). The
power cord is six feet long; make
sure there is an electrical outlet
within reach of the base. The outlet
should not be controlled by a wall
switch. If the switch is ever turned
off, the phone will not operate.
2.
Choose and mark the mounting
position.
The mounting screws should screw
into a wooden stud within the wall-
they will not hold securely in
wallboard alone. Locate a wall stud
in the area where you want to
install your telephone. Use the Wall
Mounting Template and a pencil to
mark the screw positions on the
wall over the stud (Figure 1). Put
the template aside.
3.
Install the mounting sleeves and
screws.
Start the screw holes by lightly
tapping a nail into the marks you
made on the wall. Remove the nail
from the wall. Now slip the mounting
sleeves onto the screws as shown,
with the smaller end of the sleeve
Figure 1
Figure 2
toward the screw head. Insert the
screws into the holes you started.
Tighten the screws until the large
end of the mounting sleeve is flat
against the wall
(Figure 2).
GETTING STARTED WALL MOUNTING