Filter
Top Products
46
REN is an indication of the maximum
number of devices allowed to be
connected to a telephone interface. The
termination on an interface may consist
of any combination of devices subject
only to the requirement that the sum of
the RENs of all the devices does not
exceed five.
This product meets the applicable
Industry Canada technical specifications.
California Energy
Commission battery
charging testing
instructions
This telephone is set up to comply with the
energy-conserving standards right out of
the box. These instructions are intended
for California Energy Commission (CEC)
compliance testing only. When the CEC
battery charging testing mode is activated, all
telephone functions, except battery charging,
will be disabled.
To activate the CEC battery charging
testing mode:
Unplug the telephone base power
adapter from the power outlet. Make sure
all handsets are plugged with charged
batteries before proceeding.
While you press and hold FIND
HANDSET, plug the telephone base
power adapter back to the power outlet.
After about 10 seconds, when the IN USE
light starts flashing and the telephone
base shows Registering... and then
De-register?, release FIND HANDSET
and immediately press and release
SELECT. The telephone base displays
Please wait.
NOTE
When the phone successfully enters the CEC
battery charging testing mode, all handsets
display To register HS and See manual
alternatively.
When the phone fails to enter this mode, repeat
Step 1 through Step 3 above.
To deactivate the CEC battery charging
testing mode:
Unplug the telephone base power adapter
from the power outlet, then plug it back in.
Then, the telephone base is powered up
as normal.
Press and hold FIND HANDSET on the
telephone base for about four seconds
until the IN USE light turns on and it shows
Registering...
1.
2.
3.
•
•
1.
2.