Filter
Top Products
41
I cannot dial
out.
Eliminate any background
noise. Mute the handset
before dialing, or dial from
another room in your home
with less background noise.
The display
shows To
register HS
and See
manual
alternately.
The handset
does not work
at all.
The handset is deregistered
from the telephone base. To
register it back:
Press and hold
FIND HANDSET on
the telephone base for
about four seconds
until the IN USE light
turns on and it shows
Registering...
Press QUIET# on the
handset. The handset
shows Registering...
Both the telephone base
and cordless handset
show Registered, and
you hear a beep when
the registration process
completes. This process
takes about 60 seconds.
If registration fails, the
handset displays Failed.
Repeat steps 1 to 2 again.
1.
2.
The display
shows Low
battery.
Place the handset in the
telephone base or charger
for charging.
The battery
does not
charge in the
handset or
the handset
battery does
not accept
charge.
Make sure the handset is
placed in the telephone
base or charger correctly.
If the battery is completely
depleted, charge the
battery for at least 30
minutes before use.
You may need to purchase
a new battery.
The telephone
does not ring
when there is
an incoming
call.
Make sure the ringer
volume is not set to off.
The handset may be too
far from the telephone
base. Move it closer to the
telephone base.
My handset
beeps and is
not performing
normally.
Move the handset closer to
the telephone base. It may
be out of range.
I hear other
calls when
using the
telephone.
Disconnect the telephone
base from the telephone
wall jack. Plug in a different
telephone. If you still hear
other calls, the problem is
probably in the wiring or
telephone service. Contact
your telephone service
provider.
I hear noise on
the cordless
handset and
the keys do not
work.
Make sure the telephone
line cord is plugged in
securely.
There is
interference
during a
telephone
conversation.
My calls fade
out when I
am using
the cordless
handset.
The handset may be out of
range. Move it closer to the
telephone base.
If you subscribe to high-
speed Internet service (DSL
- digital subscriber line)
through your telephone
line, you must install a DSL
filter between the telephone
line cord and the telephone
wall jack. The filter
prevents noise and caller
ID problems caused by
DSL interference. Contact
your DSL service provider
for more information about
DSL filters.
Appliances or other
cordless telephones
plugged into the same
circuit as the telephone
base can cause
interference. Try moving
the appliance or telephone
base to another outlet.
The location of your
telephone base can
impact the performance
of your cordless phone.
For better reception,
install the telephone base
in a centralized location
within your home or
office, away from walls
or other obstructions.
In many environments,
elevating the telephone
base improves overall
performance.