Filter
Top Products
42
The answering
system does
not record
messages.
Make sure the answering
system is on. When the
answering system is on,
ANS ON should display
on the handset and the
telephone base.
When the answering
machine memory is full,
it does not record new
messages until some old
messages are deleted.
If you subscribe to
voicemail service, change
the number of rings so
that your answering
system answers before
your voicemail service
answers. To determine how
many rings activate your
voicemail service, contact
your telephone service
provider.
The answering
system does
not announce
the correct day
of the week
for recorded
messages time
stamp.
Make sure you have set
the date and time. See
Congure your telephone
section.
The messages
on the
answering
system are
very difficult to
hear.
Press VOL+ on the
handset or p/VOLUME
on the telephone base
to increase the listening
volume.
The messages
on the
answering
system are
incomplete.
If a caller leaves a very
long message, part of
it may be lost when
the answering system
disconnects the call after
the preset recording time.
If the memory on the
answering system
becomes full during a
message, the answering
system stops recording
and disconnects the call.
If the caller’s voice is very
soft, the answering system
may stop recording and
disconnect the call.
The telephone
does not
receive caller
ID or the
telephone
does not show
caller ID during
call waiting.
Caller ID is a subscription
service. You must
subscribe to this service
from your telephone
service provider for this
feature to work on your
telephone.
Both your and the
caller’s telephone service
providers must use
equipment compatible with
the caller ID service.
The caller may not be
calling from an area which
supports caller ID.
The caller ID information
displays after the first or
second ring.
The display
shows Out of
range or no
pwr at base.
The handset may be out of
range. Move it closer to the
telephone base.
Make sure the power cord
is securely plugged into
the telephone base. Use a
working electrical outlet not
controlled by a wall switch.
I cannot
hear any
instruction from
the handset
when I try to
record, play or
delete my own
announcement.
The handset does not
have a speakerphone.
When recording, playing
or deleting your own
announcement, the
instructions are announced
through the handset
receiver. Make sure you
place the handset receiver
close to your ear.
The outgoing
announcement
is not clear.
When recording the
announcement, make sure
you speak in a normal
tone of voice towards the
microphone of the handset.
Make sure there is no
background noise when
recording.